Home Cosmetic Dentistry Veneers Coventional Veneers

Denture Repairs

Denture Repair Same Day Done On Premises, Jupiter Florida, Dr. Mona Sims 561 747-7172

Dr. Mona Sims DDS

Caring for patients 25 years, same location in Jupiter, Florida for 15 years.

Have a question? Ask Dr. Sims






Advanced Dental Concepts of Jupiter
Dr. Mona Sims DDS

651 W Indiantown Rd Suite A Jupiter, FL 33458
(561) 747-7172

We have 204 guests online
Home Cosmetic Dentistry Veneers Coventional Veneers
Coventional Veneers
Cosmetic Dentistry - Veneers

In dentistry, a veneer is a thin layer of restorative material placed over a tooth surface, either to improve the aesthetics of a tooth, or to protect a damaged tooth surface. There are two main types of material used to fabricate a veneer, composite and porcelain. A composite veneer may be directly placed (built-up in the mouth), or indirectly fabricated by a dental technician in a dental laboratory, and later bonded to the tooth, typically using a resin cement such as Panavia. In contrast, a porcelain veneer may only be indirectly fabricated.

When using veneers, the teeth's appearance can be changed with minimal tooth preparation (e.g. drilling). Many veneer procedures can be done with the use of little or no local anesthetic. Traditionally, a reduction of approximately 0.5 mm is required for a porcelain veneer. Composite veneers are becoming more popular as they are easy to repair, whereas porcelain veneers have potential to fracture. It can be very difficult to match the shade of an individual veneer to the remaining teeth, hence placing several veneers is common.

There are some veneers which do not require any drilling in order to remove tooth structure. Instead, these veneers are constructed to be placed on top of teeth. As a result, treatment is less invasive and may be less time-consuming. On the other hand, since the teeth are not reduced in size the veneers may appear too large or bulky unless the material used is extremely thin. Therefore, the success for these veneers is best when limited to specific cases.

Veneers may be used cosmetically to resurface teeth such as to make them appear straighter and possess a more aesthetically pleasing alignment. This may be a quick way to improve the appearance of malposed teeth without need to use orthodontics. However, the amount of malposition of teeth may be such that veneers alone may not be enough to correct them. Instead, orthodontics would need to be used, or orthodontics combined with veneers. The dentist who places veneers must be careful since veneers could increase the thickness of the front face of the teeth. If the teeth are too thick on the face they may appear to stand out and push out the lips. The effect may be enough to give the patient a full or donkey appearance when the lips are closed. Veneers must also be created such that the patient bites into them with minimal force. Otherwise, they may chip off. Patients whose lower jaw protrudes out farther than their upper jaw (known as a class III bite) may not benefit from veneers because the teeth of the lower jaw may bite into the teeth of the upper jaw such as to dislodge the veneers.